Pulse induction detector type, including discrimination! The Golden mask deep Hunter “professional metal detector to detect metal objects buried deep. Using a pulse guideline. Made in complex analog circuits based on the past achievements of the electronics in this area with the aim of achieving competitive standards. Is constructed according to the requirements of researchers on the device. Superior to traditional spring metal detectors of this type mostly with simplified management and high sensitivity, reliability and durability. Used non-traditional solutions to improve the work of automatic setting and select frequency 602-667 Hz operation.
1. set your device
1.1. electronic unit with rechargeable battery builtin provides about 6 hours continuous use for maximum power
1.2. looking for antennas:
1.2.1. the antenna with a box under (130 * 130) (to work with);
1.2.2 elliptical antenna of individual work with size (32 x 38) cm (optional)
1.2.3 frame octagonal (8 × 50) cm (optional).
1-3 charger “special additional battery charger the Golden Mask”.
2. working principle instrument works on the principle of high-frequency pulse induction in slow motion by selecting the type of metal.
3. control and signal
Voice control “on/off”-potentiometer to control the audio signal strength “power” and “off” – electronic unit.
“Power” potentiometer to control power transmission broadcast from block device
“Threshold”-potentiometer to select the frequency of the sound signal (in the absence of metal within the scope of the search device antenna).
“The Earth”-sliding potentiometer to adjust the system to remove the influence of the soil.
“Tune” button for the initial setup of the system to remove the influence of the soil, and quickly eliminate interference during operation.
“Signal”-measurement system to indicate the signal level at the time of the search.
Led indication of the type of metal:
“Green”, “red” for non-ferrous metals and magnetism.
“Battery low!” – consumer battery indicator.
System Setup to remove the influence of the soil
-Search through the antenna is placed in the area where the soil is not expected to attend the burial of metal objects.
-The power supply to the device by turning clockwise, turn on/off (3-4 to a position on the scope of the normal volume of work);
-Select the desired value from the power of the instrument (the depth of discovery) with “power” (larger values provide greater depth of detection);
-Press the “tune” and “Earth” Rotate clockwise to achieve the maximum size, and then is given the “Melody”;
“Threshold” specifies the frequency of the sound in the absence of metal within the antenna research.
metaldetector deep hunter golden mask ground test
Search for metal objects with frame
Starts using the wear and the frame horizontally above the soil about 10 cm, and long ago to “tune”. Zone control that is passed to the window, to make parallel, overlapping movements along 5-10 m trap should be at least 1/3 the size of the window. The movement is performed slowly, each signal the beginning and end. Signals that have a duration of less than 1/2 the size of the frame usually occurs because of shallow buried metal objects. Signals with greater length require careful study before crawling over and over above the soil.
Search for metal objects with a small antenna
The antenna are adjusted according to the height of the operator. The antenna is raised off its transmission, which allows the horizontal passage above ground and the search begins, and not long ago to “tune”. Tracking the movements and signals are the same with the frame.
An indicator of the presence of metals
Increasing the frequency of the audio signal measurement indicator system signal means that the antenna within the search scope on a metal object. Approaching the goal, the frequency of the sound increases. Above a certain level of signal system was an indication of the type of metal through the passing of lamps “Fe” or “n-iron.” After passing through this audio frequency decreases. Test can select “area”, which you can select the reference almost the depth and size of the object was found.
Additional information
1. when initially setting up the system to eliminate the influence of the soil, the sliding potentiometer “Earth”
– Rotation 5 (final) position.
2. “land” can be rotated clockwise after the first set, with the effect of the soil and the sensitivity of the instrument to the small metal objects is greatly reduced, and the system has to indicate the type of metals, higher resolution.
3. If during the Setup process devices that violate (indiscriminate audio signal frequency changes) without the presence of minerals within the antenna research — pressure and give a short time to “tune” one or more times, even normalizing action.
4. When you turn on the power supply signal possible short Flash battery lighter “battery low!”.
Battery indicator lit continuously while you work.
deep metal detector
10 feet deep metal detectors
what metal detector goes deepest
deepest seeking metal detector
deep gold finding metal detector
deepest penetrating metal detector
deep detecting metal detectors
metal detector with deepest range
20 Feet Deep Metal Detectors
How Deep Metal Detectors Go
Deep Search Metal Detector
Metal Detector 3 Feet Deep
How Far Down Do Metal Detectors Go
Ultra Deep Metal Detector
Deep Metal Detectors For Gold
deepest beach seeking metal detector
Deep Ground Penetrating Metal Detector
best deep search metal detector
Golden mask deep Hunter pulse metal detector with discrimination In the category Metal Detectors more articles and learn more information about Golden mask deep Hunter pulse metal detector with discrimination Reviews Price Specifications Features Image manuals videos Accessories All this in metal detectors for gold.
Tags: DEEP HUNTER, discrimination, Golden, Golden Mask Deep Hunter, mask, Metal detector, metal detectors for gold, metaldetector deep hunter golden mask, pulse
Comments
Post a Comment